logosmall
 

MEMBER BLOGS

Legendary



COMMENTS BY Legendary
Post Your Best Pic
STOLEN IDEAS
The Block is cracked
Ghost Car Video
It is really going around.. OUCH

4:10 Gears

blog Tuesday, June 20, 2006 @ 4:59 AM
  349 Views

I just bought some 4:10 gears and an intallation kit for my 2004 Cobra. I was thinking of doing the install myself at the Hobby Shop on base, but after reading a few forums, I'm thinking I might just pay to get them installed. Anybody know anywhere that I can get this done/how much it might cost. Or should I just go ahead and do it myself? I've done an axle swap on my old 96 GT but this is a bit of a different animal and I'm not sure if I should do it or not. Any suggestions??  -Mitch
POSTS BY Legendary
22" Rims for Navigator or Expedition
(0 comments)
Misc parts from Legend
(0 comments)
.020 over pistons
(2 comments)
Legend's Prodigy
(1 comments)
The Block is cracked
(6 comments)
V6 conversion
(1 comments)
V6 conversion
(1 comments)
An Update
(18 comments)
How about this for a new Legend
(5 comments)
Legend Is Dead
(15 comments)

OTHER BLOGS
blog Project FrankenRanger
483 views with (1 reply)  REEF93
blog New Job!
644 views with (1 reply)  J
blog Saleen dreams for wedding...
684 views with (9 replies)  Nicoleb3x3
blog Commitment: Getting the K...
542 views with (2 replies)  Nicoleb3x3
blog Super Coupe in a 'Stang
577 views with (4 replies)  plstktnkr2



MEMBER COMMENTS
Legendary
Jun 20th, 2006 @ 7:52 PM


“”
Per everyones suggestions I called around for a quote on the install and the best i got was $360 for the install not including parts or fluids (provided by me).  I think it is for the best.  Thanks for the advice all.   -Mitch



SHARE BLOG

 
Fuel your mustang love.
Leaderboards
gotstang owns

© 2004-2015 Gostang.com

All product names are the trademarks or registered trademarks of their respective companies

gotstang.com is not affiliated with Ford Motor Company