Swap Update - Stang back home for a few small things
Wednesday, May 24, 2006 @ 10:38 PM
Tuesday night my dad trailer'd the stang back home
over the weekend we'll be finishing up the few odds and ends...
and there's a few things I'm going to leave to the professions w/ their lift and top end tools
Right now I'm looking on solving a missing alternator wiring harness....
-->if you can tell me where the alternator harness connecs to the engine or chassis harness- please tell me! I do have a fuse link left unused near the starter relay, and I'm pretty sure it would plug into the fuse link...
-->or if you have one can you take a picture of it?
I also have a sensor or plug on the power steering tubing...I have no idea where the plug is for that...or if I need it, so if you have this plug and can take a picture for me...
well, besides that things are going well, we got a busy weekend, trying very hard to get most of this done
Finish remaining vacume lines
Find an alternator wiring harness...
plug in remaining wiring
put oil in the engine or make a tag
Plug PCV Plug off
Install Upper intake
Modify fuel pump wiring
Install 140mph gauge cluster
Install Distributor Cap, Spark Plugs and Spark Plug wire
Install Mass Air and Cold air kit
Install Radiator w/ hoses
Install front bumper and driver side fender
Remove Throttle Cable /Install new throttle cable
add power steering fluid
Trailer to Tranny/Speed shop for the following:
fix the tranny lines...if we can't by the weekend is over