THE CUSTOM TOURNAMENTS ARE UNDERWAY, PLEASE SIGNUP

GO SIGNUP NOW!! >

Close

logosmall

MEMBER BLOGS

sigpro1321

COMMENTS BY sigpro1321
	Stereo Help
	J's Sacrifice for gotstang....
	AT MY WITS END!!!!! Please Help


WIRING HELP PLEASE!!!
Sunday, July 16, 2006 @ 2:07 PM
	1322 Views Can anyone help me?, I turn my head light switch on and my headlights do not light up. the parking lights light up and if I pull on my turn signal lever back the high beams light up but the highbeams will not come on by pushing the turnsignal lever forward. The bulbs are brand new so I know it has to be wiring somewhere but I dont know where to look. Any ideas?

POSTS BY sigpro1321
	Stereo Help (8 comments)
	AT MY WITS END!!!!! Please Help (3 comments)

OTHER BLOGS
Project FrankenRanger 1575 views with (1 reply) REEF93
New Job! 27647 views with (1 reply) J
Saleen dreams for wedding... 29082 views with (9 replies) Nicoleb3x3
Commitment: Getting the K... 89991 views with (2 replies) Nicoleb3x3
Super Coupe in a 'Stang 1367 views with (4 replies) plstktnkr2

MEMBER COMMENTS

Jul 16th, 2006 @ 2:21 PM

“” have you checked out all your fuses??

Jul 16th, 2006 @ 2:27 PM

“” Hey, ford also had a lot of problems with the multifunciton switch (turn signal and highbeam switch) breaking internally...and the headlamp wiring is run through this switch. They also had problems with the connectors at the multifunction switch. You may want to pop off the steering column shroud and check to make sure none of the wire terminals have backed out of the connector. If you have tilt steering wheel, try turning the headlamps on and tilting the wheel up and down kinda hard....this will help identify a bad connection at the multifunction switch. hope this helps...good luck!!

Jul 16th, 2006 @ 2:28 PM

“” I have, they are all ok. a week or so ago I noticed that while driving my headlights were on and then went off, if I flicked the highbeams they would comeback on. now they dont come back on at all

Jul 16th, 2006 @ 2:37 PM

“” That may be it...Ill head out now and give it a try and let ya know, thx

Jul 16th, 2006 @ 4:49 PM

“” Well, took off steering column cover and all connections seemed to be ok, now th e highbeams stay on but still no headlights

Jul 17th, 2006 @ 7:51 PM

“” If you have a test light, check to see that you have power on the red/black wire going to the headlamps in low beam position with switch on...if no...check to see that you have power coming out of multifunction switch at red/black wire pin 13...if no...see if you have power going into multifunction switch at red/yellow pin 15. let me know if this helps.

Jul 17th, 2006 @ 11:28 PM

“” Check the headlight switch, Ford had a problem with some of them heating up and the wires melting together.

Jul 18th, 2006 @ 10:46 PM

“” YsOffcr is right...they(ford) have a revised pigtail to plug in that has bigger guage wire if it is melted. I had that problem on my fox and forgot all about it till now....whoa, too much carbon monoxide..

Aug 1st, 2006 @ 12:08 PM

“” well, I took off the steering column and found nothing loose or pinched so after putting that back together they are working now. So either Stephen King owned this car prior or I am going crazy. I have already replaced that switch once I think it was last year. Ill pull it out and check again. (&^%$%$^%$*&^!!!!

SHARE BLOG

Fuel your mustang love.

Member Info

Mustangs by Year

Compete

Leaderboards

More

gotstang owns

© 2004-2015 Gostang.com

All product names are the trademarks or registered trademarks of their respective companies

gotstang.com is not affiliated with Ford Motor Company