gotstang.com - Mustang HOWTOS

THE CUSTOM TOURNAMENTS ARE UNDERWAY, PLEASE SIGNUP

gotstang.com - got stang? - HOWTO: How to Install CDC Sequential Taillights

How to Install CDC Sequential Taillights
(The product and installation applies to any 2005+ Mustang. Its easy, requires minimal time, tools, and money for parts. You can purchase the sequential taillights from www.classicdesignconcepts.com for $150. They are my favorite minor exterior modification for the new mustangs. TOOLS NEEDED: 1. 11mm wrench OR 1/4" drive 11mm deep well socket and ratchet 2. T-30 Torx Bit with Driver TIME REQUIRED: 40-60mins)

Step 1: Intro and Open Trunk

Step 2: Taking out the trunk trim

Step 3: Taking out the trunk trim

Step 4: Unbolt taillight housings

Step 5: Unplug stock harnesses

Step 6: Remove Taillight housings

Step 7: Make hole in grommet

Step 8: Sequential wire in hole

Step 9: Slice blue grommet

Step 10: Insert wire into terminal

Step 11: Reinsert bulb

Step 12: Tape sequential wire

Step 13: Plug in new harnesses

Step 14: Reinstall taillights

Step 15: Plug inside of trunk

Step 16: Test the signals

Step 17: Tighten all nuts

Step 18: Reinsert trim piece

Step 19: Double check trunk

Step 20: COMPLETION!

Taking out the trunk trim

[ click to enlarge ]

Remove the two Torx Head Plastic Screws from the upper Area of trim panel, one per side, directly behind each taillight in trunk. Remove trim panel, (its not necessary to move the shaker 1000 stereo subwoofers if you have them).

Fuel your mustang love.

Member Info

Mustangs by Year

Compete

Leaderboards

All product names are the trademarks or registered trademarks of their respective companies

gotstang.com is not affiliated with Ford Motor Company