gotstang.com - got stang? - HOWTO: How to Install CDC Sequential Taillights
View Other HOWTOs

How to Install CDC Sequential Taillights
(The product and installation applies to any 2005+ Mustang. Its easy, requires minimal time, tools, and money for parts. You can purchase the sequential taillights from www.classicdesignconcepts.com for $150. They are my favorite minor exterior modification for the new mustangs. TOOLS NEEDED: 1. 11mm wrench OR 1/4" drive 11mm deep well socket and ratchet 2. T-30 Torx Bit with Driver TIME REQUIRED: 40-60mins)

Step 1: Intro and Open Trunk
Step 2: Taking out the trunk trim
Step 3: Taking out the trunk trim
Step 4: Unbolt taillight housings
Step 5: Unplug stock harnesses
Step 6: Remove Taillight housings
Step 7: Make hole in grommet
Step 8: Sequential wire in hole
Step 9: Slice blue grommet
Step 10: Insert wire into terminal
Step 11: Reinsert bulb
Step 12: Tape sequential wire
Step 13: Plug in new harnesses
Step 14: Reinstall taillights
Step 15: Plug inside of trunk
Step 16: Test the signals
Step 17: Tighten all nuts
Step 18: Reinsert trim piece
Step 19: Double check trunk

Plug inside of trunk

Plug the mating Sequential Control Board Pigtail into the Taillight harness inside of the trunk
Fuel your mustang love.
gotstang owns

© 2004-2015 Gostang.com

All product names are the trademarks or registered trademarks of their respective companies

gotstang.com is not affiliated with Ford Motor Company